|
Post by mrfixitnow on Feb 6, 2011 21:47:16 GMT
hi all am buying another cylinder head for my rex going to have it checked for being flat ect,im sure its going to be fine but just in case i thought id ask you whats the most you can skim off with out touching the pistons ect be grateful if any one knows ta
|
|
|
Post by Burchy on Feb 7, 2011 9:23:08 GMT
Don't know of anyone who has skimmed a head. Those who are looking for increased CR will remove the base gasket, but that's about it. The CR is pretty high as standard and you would soon get into knocking issues if you were using a +4 advancer 'frinstance
|
|
|
Post by mrfixitnow on Sept 9, 2011 18:47:44 GMT
its all ok had the head fitted,(yes im that lazy)zzr cams +valve springs and 3 months of port polishing,lost a little power down low trys to lift the wheel after 6.5k all good,also it seams to have gotten quite a bit louder gggrate
|
|