|
Post by wd650 on Oct 7, 2006 15:10:35 GMT
Aloha need to adjust headstock bearings on said bike I dare say same procedure as most K. Now as its not got a centre stand and have no way of jacking up front end off the ground plan to do proceedure with bike on tera firma, not ideal i know. Now i dare say it goes; loosen top steering bolt, loosen top yoke clamp bolt,loosen bottom yoke bolts,adjust bearings.tighten top bolt,rear clamp bolt then bottom yoke bolts. does any one have the info of the correct torque settings of said fasteners? if itsreccomended to get front end up in the air then whats the best method n how?
|
|
KES
Stuck in the saddle
Posts: 451
|
Post by KES on Oct 7, 2006 15:38:01 GMT
Hi , you will need the front end op . Pikeys version , one person ( 2 preferably) lift front end up other perso axel stand under each lower frame rail towards the front . Check bearings genltly pushing the the forks in and out . To adjust , top yolk nut and clamp bolts NOT the bottom ones or your forks will just slide through the yolks . Check movement of forks , with a finger tip push motion to start then thier own wgt should carry them on . To tighten the C nut under the top yolk use a screw driver and hammer and gently tap the seration in the nut . When satisfied tighten the top yolk nut first then the yolk bolts .
|
|